DOS Command Numlock

Home
About
How to use software
How to use Windows
Computer Issues
Computer parts info and install instructions
How to perform tasks and other information
Troubleshooting Tools
Remote Services
Downloads
Info on Websites and/or Businesses
Contact
I have put this website up for your convenience. The website and email service is free, but if you find this site helpful and would like to make a donation, click on the donate button above. Thank you!

DOS Command Numlock

Type: Internal (6.0 and later)
NUMLOCK=on|off

Purpose: Used in the CONFIG.SYS file to specify the state of the NumLock key.

Discussion

NUMLOCK=on causes the NumLock key to be ON (the number keys on the keypad will be active) upon system start-up. NUMLOCK=off causes the cursor keys on the keypad to be active.

This page is from http://www.easydos.com. I pasted it on my website to avoid possible broken links. For further help with DOS commands, Check easydos.com out.

Contact Email: Support@upgradenrepair.com

DISCLAIMER:UpgradeNRepair (UNR), the owner, and any representatives of UpgradeNRepair (UNR) is not liable for any data loss or hardware failure because of the following procedure. The Information provided is a guide to assist the customer with an issue with their system or software. The procedures offered here may or may not harm your files. Even procedures that are not designed to harm files, can harm files, depending on the issue with the system. Because there is too many unknowns, UpgradeNRepair is unable to guarantee the safety of the files. Customer is responsible for their data and their actions. Before following the directions on this page and the pages these links are linked to, any data the customer does not want to lose will have to be saved. Saving the data is the sole responsibility of the customer. Some or all of the following procedures or information may not apply to your situation.